Veris-technologies pH Detector - Operating Instructions Manual de usuario

OM17-pH Detector pH Detector Table of Contents Section 1 1-1 Warranty 1-2 Safety Section 2 2-1 pH Detector Assembly and Set-u

OM17-pH Detector 2-7 Important – Do not allow moisture to enter the Sensor Data-Logger, and do not pass strong magnets near the unit. Mount instrume

OM17-pH Detector 3-1 SECTION 3 Field Operations Testing functions: Turn external controller power switch on, and check operation using status LED’s

OM17-pH Detector 3-2 -Flush and fill tanks with tap water; clean any foreign matter out of tank using clean-out cap. Make sure inlet is in sump (Fig

OM17-pH Detector 3-3 Insert pH electrode into electrode holder. Finger-tighten plastic screw as tightly as possible by hand. If a wrench is used, be

OM17-pH Detector 3-4 Sensor DataLogger display Here are the display readings that you will see when operating the Sensor DataLogger: Starting up…

OM17-pH Detector 3-5 Figure 14 Figure 15 The instrument will read the electrodes for 10 seconds, displaying the output (as it counts seconds): F

OM17-pH Detector 3-6 After accepting the pH 7 buffer readings, the electronics firmware will determine if the electrode’s response is sufficient to p

OM17-pH Detector 3-7 pH Controller Set-up After calibration, you may wish to change the pH Controller default parameters. Press 2 and enter Setup m

OM17-pH Detector 3-8 Figure 24 The DataLogger is displaying the map file number it is creating, in case you want to record it along with any other

OM17-pH Detector 3-9 Probe Operations Release the brake and step on the foot lever to insert the probe chamber into the soil (Figure 27). This movem

OM17-pH Detector 1-1 SECTION 1 pH Detector Sensor DataLogger Version 1.03 Warranty Veris Technologies warrants this product to be free of defects

OM17-pH Detector 3-10 Figure 29 Allow the sampler to remain in the soil while the readings settle, as indicated by the In Progress red LED (Figure

OM17-pH Detector 3-11 At any time during the mapping process, you can press the #4 key to stop the file. If you create more than one file from the s

OM17-pH Detector 3-12 Data quality tips As you collect pH data, monitor the performance of the system by observing the following: -During ‘Cycling’

OM17-pH Detector 4-1 SECTION 4 Maintenance and Service pH Electrodes Figure 1 • Antimony is harmful if ingested into your skin, mouth, or lungs

OM17-pH Detector 4-2 Wash System If wash water develops algae, flush and fill tanks with tap water; clean any algae or other foreign matter out of t

OM17-pH Detector 4-3 Adjustments/troubleshooting: Electrode holder won’t go into soil: 1) If door is not completely open when electrode holder trie

OM17-pH Detector 4-4 3) Verify that bottom jam nut on pivot rod hasn’t slipped. If hand lever does not move door, retightening pivot rod jam nut is r

OM17-pH Detector 4-5 Figure 9 Upper switch needs to be in activated position only when electrode holder is fully inserted into the probe chamber (F

OM17-pH Detector 4-6 Excessive movement of assembly while driving: tighten up spring tension on main springs (Figure 11). Figure 11 Probe does

OM17-pH Detector 4-7 Lubrication Weekly: Apply dry powdered graphite to slides in wear blocks shown in Figure14. Figure 14a Figure

OM17-pH Detector 1-2 Important! Read the following SAFETY PROCEDURES before operating the Veris system: • Read and understand all instructions on

OM17-pH Detector 2-1 SECTION 2 pH Detector Assembly and Set-up OVERVIEW: The pH Detector collects a geo-referenced pH reading each time the pH elec

OM17-pH Detector 2-2 Tools required for Assembly and Field Operation adjustments -3/16” allen wrench -7/16”, 1/2”, 3/8”, 9/16”, 3/4” wrenches and/o

OM17-pH Detector 2-3 Attaching pH Detector to ATV Mount tank to rear rack of ATV using nylon straps or zip ties through holes in tank base(Figure 4

OM17-pH Detector 2-4 Figure 8a and 8b Bolt pH controller to unit (Figure 9). Figure 9

OM17-pH Detector 2-5 Electronics Overview and Set-up The Veris Sensor Data-Logger kit includes the items shown in Figure 10. Figure 10 Use

OM17-pH Detector 2-6 Figure 11 DataLogger (rear) Figure 12 Data-Logger (front) Power: When lit, this red LED indicate